Buda-style HotEnd v2.0 - pre-assembled
KIT INCLUDES:
- Heater Block
- Nozzle (0,4mm/0,0157inch and 0,5mm/0,0196inch)
- Black Peek Isolator
- Aluminum extension
- Upper Plate
- Lower Plate
- Backup Plate
- Copper Heatsink
- Budaschnozzle Mount
- Ceramic Heater (40W/12-24V) with 1meter length cable
- EPCOS 100k thermistor with 1meter length cable (40')
- Fan Cooler (for cooling upper part of hotend for PLA printing) - 10cm of white plumbing tape (for secure threading in case if you want to printing using PLA which is more liquify) - screws, washers, spacers set
SPECIFICATIONS:
- Size at longest parts: (H,W,L) 57mm, 40mm, 40mm / 2,24inch, 1,57inch, 1,57inch
- Aluminum heater block
- Machined aluminum heat block: 18.4mm x 25mm x 8.3mm / 0,72inch, 0,98inch, 0,33inch
- M10 x 1.0 internal thread
- Machined aluminum nozzle, M10 x 1.0 internal thread, 0.4mm/0,0157inch and 0,5mm/0,0196inch (both are included) orifice
- Thermistor temperature reading: EPCOS 100k
- Ceramic heating element: 40W/12V (Diameter: 6mm (0,24inch), Tube Lenght: 25mm (0.98inch)
- Aluminum and copper heatsink
- Black PEEK insulator
- PTFE inner sleeve
- Laser cut special acrylic plates
- For use with 3mm filament. 1.75mm filament can be used by changeing the inner PTFE tube (Included only 3mm PTFE tube)
- Machined stainless steel back-up plate
