E3Dv6 Dual extruder - Prusa i3

8223800002469
€140.41
Tax excluded
X-axis carriage
NEMA 17 step motor (+1m wire)
G3D Fan splitter
Axial cooling fan

E3Dv6 Dual extruder - Prusa i3

The kit includes:

  • ABS printed parts:
    • E3D v6 (two pieces) mount and clamp
    • Axial fan mount piece
    • Fan cooling nozzle 
  • Metal parts:
    • 2 x Aluminium Heatsink
    • 2 x Stainless Steel Heatbreak
    • 2 x Stainless Steel Heatbreak
    • 2 x Brass Nozzle (0.4mm)
    • 2 x Aluminium Heater Block 
  • Electronics
    • 2 x 100K Semitec NTC thermistor
    • 2 x Heater Cartridge (12v)
    • 2 x 30x30x10mm fan (12v)
    • 2 x High Temperature Fiberglass Wire - for Thermistor (150mm)
    • 4 x 0.75mm Ferrules 
  • Fixings:
    • 8 x Plastfast30 3.0 x 16 screws to attach the fan to the fan duct
    • 2 x M3x3 socket dome screw and M3 washer to clamp thermistor
    • 2 x M3x10 socket dome screw to clamp the heater block around the heater cartridge
    • 2 x Fan duct 
  • Bowden
    • 2 x 750mm de tubo PTFE
    • 2 x Screw in Coupler for extruder end of tubing. 
  • Hardware: bolts, nuts etc to fix the hotend mount to x-carriage.

 

FAQ

Why are there options to choose instead to offer a complete and closed kit?

Generally, the installation of a dual extrusion requires a higher of both the mechanical and the electronics knowledge, which usually this is because the user already has a 3D printer. In this case, user can recycle parts of his printer, or print his own parts, saving on cost.. 

What is the SPLITTER for?

This small electronic board, makes it easy to install a fan which can be controlled individually and its revolutions. Since the dual system, occupies the output ports D8, D9 and D10 to the two hotends and heatedbed, it requires installation of a system that enable the use and conversion of a 5V auxiliary pin to a 12v pin in order to be used for fan. This electronic board will facilitate this process with a simple connection. This board will provide up to 10 x 12v output continuous fans and 2x12v output ports of PWM, activated in firmware or gcode..

Is it possible to purchase a more complete set including 2 filament feeders?

Of course, we recommend you to installa a bowden system and we can advise and guide you with this requeriments.  recomendamos instalar un sistema bowden y podemos orientarte y ayudarte en esta opción. You just have to send us an email: info@3dprinters-shop.com

Are these products ORIGINALS?

We are distributors of E3D-online, so our products are guaranteed in quality.

No reviews
Product added to wishlist
Product added to compare.

This store uses cookies and other technologies so that we can enhance your experience on our website. By using our website accepts the use of cookies. You can get more information about cookies and their use on our website in the section Terms and Conditions, paragraph 4. pressing "Accept" accepts the cookie policy of this website: