Buda-style HotEnd v2.0 - pre-assembled

BUDA-STYLE HOTEND V2.0 - PRE-ASSEMBLED

El kit incluye:

 - Heater Block

- Nozzle (0,4mm/0,0157inch and 0,5mm/0,0196inch)

- Black Peek Isolator

- Aluminum extension

- Upper Plate

- Lower Plate

- Backup Plate

- Copper Heatsink

- Budaschnozzle Mount

- Ceramic Heater (40W/12-24V) with 1meter length cable

- EPCOS 100k thermistor with 1meter length cable (40')

- Fan Cooler (for cooling upper part of hotend for PLA printing) - 10cm of white plumbing tape (for secure threading in case if you want to printing using PLA which is more liquify) - screws, washers, spacers set

Especificaciones:

 - Size at longest parts: (H,W,L) 57mm, 40mm, 40mm / 2,24inch, 1,57inch, 1,57inch

- Aluminum heater block

- Machined aluminum heat block: 18.4mm x 25mm x 8.3mm / 0,72inch, 0,98inch, 0,33inch

- M10 x 1.0 internal thread

- Machined aluminum nozzle, M10 x 1.0 internal thread, 0.4mm/0,0157inch and 0,5mm/0,0196inch (both are included) orifice

- Thermistor temperature reading: EPCOS 100k

- Ceramic heating element: 40W/12V (Diameter: 6mm (0,24inch), Tube Lenght: 25mm (0.98inch)

- Aluminum and copper heatsink

- Black PEEK insulator

- PTFE inner sleeve

- Laser cut special acrylic plates

- For use with 3mm filament. 1.75mm filament can be used by changeing the inner PTFE tube (Included only 3mm PTFE tube)

- Machined stainless steel back-up plate