Prusa i3 DUAL EXTRUDER - UPGRADE KIT

DUAL EXTRUDER Upgrade Kit, print with 2 different colours or materials!!

Kit includes:

 - Printed parts set:

• X-Carriage adapted
• X axis belt stopper
• X-Carriage bowden coupling adaptor

- 4 x Pneufit straight adaptor 1/8in X 6mm

- 1 x NEMA 17 step motor

- 2 x PTFE guide tubes (70cm each)

- 1 x Aluminum plate, j-head hotend holder

- 2 x 12V0.1A Fan

- 2 x j-Head hotends sets:

• Black PEEK holder
• PTFE inner tubes
• Thermistors
• Heater resistances
• Nozzle

 - 1 x Hardware set (bolts, washers, nuts, ties, 3xLM8UU bearing)

 - 2 x MK7 drive gear

 --------------------------------------------------

ASSEMBLY  GUIDE: http://www.3dprinters-shop.com/documentacion/DUPLEXT%20_%20Dual_extruder_Assembly_GUIDE.pdf

IMPORTANT: The max operational temperature is 247 degrees as the peek will start to become some at this point. However,  approaching this point you should already be carefull not to use to much force or the nozzle may be pushed out of the holder.

NOTE: This UPGRADE will allow you to install a dual extruder on X-Axis. You will need to have two filament extruder. If you need any help about this point, please contact us!